GENERAL FEATURES

With a single introduction of the hands –gloved or not- into the unit’s interior, the machine automatically emits a hydroalcoholic and dermoprotective disinfectant which rapidly evaporates. No physical contact is necessary thanks to the infra-red detection system. The housing is made of stainless steel for easy inspection, as is the liquid tank for sterilisation by steam autoclave.

Advantages:
• Speed: in only 1,5 seconds doses enough liquid to disinfect the hands.
• Efficiency: reduction in microbes by more than 90%.
• Hygienic: as no physical contact is necessary, cross-contamination is avoided, the entire unit can be fully disinfected and the deposit tank can be sterilised.
• Convenience: easy to install on walls or surfaces.
• Economical: uses only 0.5 ml of disinfectant in each spray cycle.

Uses:
Disinfecting of hands in the Pharmaceuticals, Food, Cosmetics, Hospitals and Biotechnology industries, amongst others.
All kinds of applications in the clinical sphere where asepsis is required.

Go to products list / contact

 
         
   
   
 
 
 

TECHNICAL SPECIFICATIONS

The HANDYCLEAN basically consists of three parts:
• The CPU electronic system
• Tank / liquid piping system
• The liquid propulsion circuit

Technical characteristics:
• Voltage: 110 / 220 V at 50/60 Hz
• Width: 275 mm
• Depth: 220 mm
• Height: 260 mm
• Weight: 9 Kg
• Housing and tank made from AISI 304 stainless steel
• Low tension transformer (24 V) to users safety.
• Capacity of tank : 500 ml
• Volume of spray cycle: 0.5 ml

CPU Electronic System:
This is the microprocessor control unit in which dosage times have been programmed. It also carries out visual and sound control tests, systematically monitoring the level of liquid in the tank.

Tank:
The tank is made of stainless steel with an airtight Teflon lid which means it can be steam sterilised ( 120º 30’) if required.
Filling the tank up unscrewing the stainless steel top.

Liquid propulsion circuit:
This consists of a pressure pump and an electrovalve. An infrared sender-receiver sensor and the vaporiser outlet are located in the front cavity.

Light /Sound Indicators
• Red light : Indicates voltage in the mains.
• Green light:
a) Off with intermittent humming: Lack of liquid.
b) On with continuous humming: Maximum Level.
c) On and no humming: Normal Mode.

Go to products list / contact